Provides optimum protection For rear sprockets up to 50T and 220 mm - 260 mm brake discs.
Use this to remove the dirt from your last mud battle with ease! A motorcycle grip rubber (not included) can be fitted to the grip.
Magnetic. Never lose a bolt again! Perfect for use in combination with the SX stand.
100 mm length 20 blades: 0,05 - 0,1 - 0,15 - 0,2 - 0,25 - 0,3- 0,35 - 0,4 - 0,45 - 0,5 - 0,55 - 0,6 - 0,65 - 0,7 - 0,75 - 0,8 - 0,85 - 0,9 - 0,95...
Never again cold fingers! Mounting over handlebar and switches Better control during winter ride-outs
Provides optimum protection For rear sprockets up to 50T and 220 mm - 260 mm brake discs.
Use this to remove the dirt from your last mud battle with ease! A motorcycle grip rubber (not included) can be fitted to the grip.
Magnetic. Never lose a bolt again! Perfect for use in combination with the SX stand.
100 mm length 20 blades: 0,05 - 0,1 - 0,15 - 0,2 - 0,25 - 0,3- 0,35 - 0,4 - 0,45 - 0,5 - 0,55 - 0,6 - 0,65 - 0,7 - 0,75 - 0,8 - 0,85 - 0,9 - 0,95...
Never again cold fingers! Mounting over handlebar and switches Better control during winter ride-outs
Tool for pressing in components (DU bush in seal ring retainer)
Tool for filling the damper with nitrogen
Tool for clamping components (outer tube, fork leg)
Tool for mounting and pressing out components (dirt scraper, DU bush)
Tool for pressing in components (heim joint)
Tool (including chassis, crank rotation mechanism, oil pan, and engine bracket) for mounting the rem...
Tool for securing the removed engine on the engine work stand
Tool for holding components (clutch, primary gear wheel)
Tool for securing components (steering head bearing)
Torque wrench with various bits in the kit for tightening fittings to tightening torque (spokes)
Tool for dial gauge, for checking the X dimension (piston protrusion)
Measuring device for measuring lengths or length differences, for checking the X dimension (piston p...
Tool for pulling off components (rotor)
Tool for pulling off components (inner bearing race of crankshaft)
Tool for removing and mounting rider footrests
Tool for pressing components in and out (radial shaft seal ring of crankshaft)
Tool for driving components out (collar bushings)
Tool for protecting components (thread of piston rod)
Tool for loosening and tightening components (screw cap)
Tool for mounting components (piston rod in the air cartridge)
Tool for removing and pressing in components (pilot bushing)
Tool for bleeding and filling dampers